Roof Replacement in Cedar Hills, OR

A full tear-off, soft decking replaced, and every penetration renewed before the Chateau Green shingles went down.

📞 (503) 203-1483
← Back to Project Gallery

Published November 21, 2026 · Cedar Hills, Oregon

We tore off and replaced 2,500–3,500 square feet of standard-pitch roof on a house in Cedar Hills, Oregon, and shingled it in Owens Corning TruDefinition Duration in Chateau Green. Three days on site, start to finish.

The deck had soft spots and a hole, so that got fixed before anything went back down. Every penetration on the roof (pipe boots, exhaust vents, chimney flashing and the skylight) came off and went back new.

  • Scope: complete tear-off and replacement
  • Shingle: Owens Corning TruDefinition Duration architectural asphalt, Chateau Green
  • Underlayment: Owens Corning ProArmor synthetic, with a self-adhered ice-and-water membrane at the eaves
  • Pipe boots: GAF Master Flow Pivot, 50-year
  • Roof area: approx. 2,500–3,500 sq ft, standard pitch
  • Time on site: 3 days
  • Project cost: $15,000–$20,000
  • Also done: damaged plywood replaced, new chimney flashing, new skylight, new exhaust vents and pipe boots

Tear-off: what the old roof was hiding

Stripping to the bare deck is what shows the real condition of a roof. Here it showed soft plywood and an unpatched cut around a duct, which would have been shingled over on a cover-up job.

New CDX plywood sheets replacing soft roof decking on a Cedar Hills, Oregon roof replacement
The light-colored panels are new CDX plywood where the old decking had gone soft. We cut back to solid framing and land every edge on a rafter. The old box vent is pulled and disposed.

Dried in before shingles

Ice-and-water membrane goes on first at the eaves, then synthetic underlayment over the rest of the deck. Synthetic doesn’t wrinkle, buckle or tear the way old felt paper does, so it lies flat and the shingles sit flat on top of it. It also keeps the house dry if weather moves in before the roof is shingled.

Roof dried in with synthetic underlayment and Owens Corning Duration bundles staged along the ridge
Dried in, with the shingles on the roof. Bundles are staged along the ridge so the crew works downhill. The two pipe stubs standing through the underlayment are the plumbing vents, waiting on their new boots.

Shingles, flashing and venting

A standard pipe boot uses a rubber collar around the pipe, and that rubber is the first thing on a roof to fail. These boots wrap the pipe in metal instead, so the flashing lasts as long as the roof over it.

New 50-year metal pipe boot flashing set as Chateau Green shingles go on
Shingles start at the eave off a starter course and run up in courses. The black boots are the new 50-year pipe boots going in around the plumbing vents.
New step flashing at a brick chimney on a Chateau Green shingle roof
New step flashing at a brick chimney.
Row of new exhaust vents installed below the ridge on a new Chateau Green shingle roof
New exhaust vents set in a line just below the ridge. A row at a consistent height keeps the airflow even across the attic instead of pulling hard from one corner. Additional vents were added to meet building code.
New exhaust vents and capped hip line on the rear slope of a Cedar Hills, Oregon roof
New exhaust vents and the capped hip line on the rear slope.

Finished result

Finished hip and ridge caps with exhaust vents on a Chateau Green shingle roof
Hips and ridges capped off. Cap shingles are a separate piece that bends over the peak and is nailed through both slopes.

Tear-off debris was hauled off site, the yard and driveway were swept with a magnet for nails, the gutters were cleaned out, and we finished with a walkthrough with the homeowner and the manufacturer warranty registered.

More about how we handle a full roof replacement, or what else we cover under roofing services.

Planning a new roof? To have us look at yours, request a free written estimate.